Wpc flooring because of its environmental protection, health, beauty of many owners of the favorite, but in recent years there are some flooring installed after the bubble problem, often upset the owners, whether it is quality, or because of moisture? Next, Ke Fei floor Xiaobian with everyone to understand the real wood flooring bubble causes why? Often in the family life because of accidentally spilled water on the floor, or the floor due to rain, and the bubble, so seriously affect the appearance of the floor. So why the floor will blister it? What is the solution? Most consumers also complained that Wpc flooring board paint blister is the product quality problems.
After all, the floor is wood products, certainly can not withstand blisters. But sometimes the wood floor is not soaked, why have the phenomenon of blistering it? Floor blisters There are two types of blistering locations: edge blistering and blistering. Edge of the bubble is the floor edge of the elliptical drums, there are single or multiple packages in the middle of the two floors, and some even into one, in the room irregularly distributed; board blistering is the floor plate oval Drums, the same irregular distribution in the room, seriously affecting the appearance, also affect the life of the floor. (1) the majority of ground moisture in the new building or from the kitchen and bathroom closer to the living room, the floor are varying degrees of tile-shaped (1) the surface of the water, Deformation, in severe cases, the phenomenon of squeeze the board surface, the crack plate are along the grain direction of the wood (longitudinal) arrangement. The wider the room, the floor tile deformation appears more serious, the floor surface cracks more. But in sunny, relatively dry room or away from the water source of the room, the floor sometimes there will be a slight tile deformation, it is difficult to explain.
In fact, if the use of the method is not correct, moisture from the floor below can still flee into the room, but away from the water where the degree of wet weakened, the degree of floor damage decreased. In wet ground, if the moisture-proof membrane connection is not sticky with waterproof tape, although the floor of the back of the balance layer is not damaged, the floor for a long time in a humid environment, the balance layer is moisture erosion, moisture may enter the floor, So that the floor is damaged. (2) due to the floor patchwork at the water caused by the drum package phenomenon (such as: hot soak, a large area of water, etc.), is the use of improper maintenance problems, even moisture measures do better, but also anti-water.
Small series of recommendations: in the whole house decoration, wood flooring is not very difficult to maintain the product, routine maintenance as long as a little attention, you can extend the life of wood flooring, to avoid some problems. In addition to product quality factors, the daily life of the ground floor can not be a large area of water, the rainy season comes close at any time to close the windows, to avoid being wet; clean as far as possible with a vacuum cleaner or semi-dry mop to take care of, Can not use the dripping mop mopping the floor, if accidentally spilled to the Wpc floor surface, immediately wipe with a dry cloth to prevent leakage of water from the floor seams. Or with a hair dryer with a cold air dry, but do not use hot air to prevent the surface due to heat drying caused by dry deformation.
Related links: